» Fixtures »Support for collector repair

Manifold Repair Stand


When rewinding the armature of the collector motor, it becomes necessary to rivet the "cocks" of the collector. Since the anchor is made in the form of a cylinder, then when it hits the cockerel through the tip, it scrolls. This creates some inconvenience. To prevent the anchor from spinning, by homemade such a device was created.


Tools and materials:
-Bar 4 * 4 * 10 cm;
-Pen on 25;
-Two studs at 6;
-Eight nuts and washers on 6;
Drill with a drill at 6;
-A circular saw;

First, the author makes a hole in the center of the beam with a pen.

Then it cuts the bar in half and drills a hole at the edges with a drill.

It inserts studs and fixes on both sides with nuts.



The result was such a design.


Now, when riveted, the anchor will not spin.




Since the supports move, then for repair you can use anchors of different lengths.
10
10
10

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose

We advise you to read:

Hand it for the smartphone ...