This feeder is designed to catch almost all white fish on the lakes.
These are: Crucian carp, Roach, Red rudd, Spoiler ...
For the manufacture we need:
1. Lead Sheet
2. Cap from a five liter bottle
3. Cambric or stick from lollipop
4. Marker
5. Scissors
6. Awl.
To get started, draw a circle around the circle on the lead plate with a marker.
Then with scissors we cut out the marked circle.
Using an awl in the sides of the lid we make two holes for the cambric.
The next step is to pierce the hole in the middle of the cap.
We put the lid on top of the lead circle and mark the puncture with an awl.
We expand the holes with the same awl. We select a small screw with a nut and fasten the cover with a lead circle.
We insert the cambric back into place (if it is slightly free, fix it with glue).
The feeder is ready.
Equipped. We draw the main line through the cambric. We fix by installing along the edges of the feeder along a bead or lead pellets (the distance between the pellets is about 20 cm.
At the end of the main fishing line we knit a loop (to change the thickness and length of the leash).
The best option is, the main line is about 0.2 and the leashes from 0.1 to 0.15 mm. We select the hook accordingly under the fish we are going to catch.
In the photo, I took the fishing line thicker to make it clearer. A foam ball indicates bait.
That's it.
We bait half the lid, then insert the hook with the bait and cover the top with the same bait. Good luck.