For a glider we need:
stick for sushi rolls
-clip
-plasticine
-cardboard
-insulating tape
From the tools we need:
glue (I used hot glue)
-scissors
So, let's begin.
First you need to cut the wing and tail of our glider, I made a wing 22 cm long and 4.5 cm wide, and the lower part of the tail 7.5 cm long and 4.7 wide. But you can experiment, it's even more interesting
Then they need to be glued to sushi sticks.
We retreat from the beginning of the stick 4-6 cm and glue the wing evenly.
Then on the back side we retreat 1 cm (we will need this gap to hold our glider when starting from a slingshot) and glue the lower part of the tail:
Now bend the paper clip as shown in the photo:
and glue to the front of our glider and wrap with tape for strength:
Cut the top of the tail out of cardboard:
And glue to the bottom:
Now we take a piece of plasticine and glue it as a weight to the nose of the glider:
Here we have such a cool glider!
You can run it from a homemade slingshot, which I specifically made for airplanes
Thank you all for your attention and be careful.