And so for him we need:
ice cream sticks
-2 hairpins ("invisible hair")
threads
-matches (we will use them as arrows)
From the tools we need:
-stationery knife
hotmelt
nippers
And so, for starters, take an ice cream stick and use two nippers to bite off two identical pieces about 2 cm long:
Now you need to glue the studs to one of the blanks:
And stick on top the remaining workpiece:
We bite off the ends of three sticks of ice cream using nippers:
And we glue them in such a way that between them we get a groove into which the match will fit in half:
Take another wand and divide it by gender:
And glue, so that we get a mini crossbow handle:
We glue the first design to the second, as shown in the photo:
We bend the studs a little and tie the thread stronger (can also be glued for strength)
Move the thread to the maximum back, make a mark in this place and use the stationery knife to serif:
Take another ice cream stick and bite off 2 pieces of 2-3 cm and 3.5 cm long:
And glue them to the mini crossbow, this addition is necessary so that the "bowstring" of the crossbow does not fly up when fired
Well, that’s it, the mini crossbow is ready! In order to shoot, you need to push the "bowstring" back, put a match in the groove, take aim and slide the bowstring with your finger up from the serifs, so the mini crossbow will fire. And do not forget about safety!
Thank you all for your attention!