And so for her we need:
foam box
-engine from 1.5 to 9 volts
-3 small bottle caps
- large bottle cap
-tube
-plastic bottle
box for batteries
-2 AAA batteries
pens for barbecue sticks or sticks
ice cream sticks
From the tools you will need:
thermal glue
-stationery knife
soldering iron
And so, for starters, cut a piece of about 20 by 10 cm from the foam box:
And glue a small cover, as shown in the picture:
We cut out two more foam parts:
And glue to the platform:
Cut two equal pieces from the tube, about 10 cm in length:
And glue to the back of the platform:
We take two small caps and with the help of a hot nail we make a hole in it exactly in the center - these will be the “wheels”:
Glue as evenly as possible to the rod from the handle:
We put it into the back tube and glue the second "wheel", you also need to glue the electric motor to the top cover so that it "looks back"
We also make a hole in the big lid:
Cut a piece of about 5 cm in length from the second rod and put it into the lid and glue it:
Then cut off two equal pieces 2-3 cm long from the tube and glue the ends to them:
We divide the ice cream stick into two equal parts:
Glue to the "front" of the platform, as shown in the photo:
We insert the axis of the "wheel" into the tubes and glue:
Cut a rectangle 10 cm long and 1 cm wide from the bottle, then heat the edges of it and form the propeller blades (ideally, use a ready-made propeller right away)
And glue it to the axis of the motor:
Using two sticks, we fix the bottom of the platform:
We glue the box with the batteries:
We take a soldering iron and solder the wires and the switch into the circuit, so that the air flows move from the structure:
We glue the switch and carefully remove the wires so as not to interfere:
That's it! Our airboat is ready! In order for it to go, you need to put it on a smooth surface and turn it on. The airboat is pretty nimble and it will be fun to play with!
Thank you all for your attention!