» Fixtures »Nightlight from the old garlands

Nightlight from the old garlands


Today, there are many original workshops on assembling beautiful lamps for lighting a children's room and bedroom. Some models of home-made nightlights can be assembled from improvised materials in no more than an hour.

Let's get started.

Materials:
1. Old garlands
2. The board is 10 by 10 cm.
3. Glass jar 0.4 l.
4. Power supply 12 V, 1.5 A


Instruments:
1. Drill
2. Drill 4 mm.
3. Screwdriver
4. Glue gun
5. Soldering iron (solder, flux ...)

To begin with, we cut three light bulbs of different colors from garlands, in my case it is: red, yellow, green.

Take a board and clean it with sandpaper, from all sides.

If desired, you can varnish the board, which I actually did.

Next, we attach the lid from the can to the plank and fasten it with two screws, as in the photo. Then we drill a through hole with a 4 mm drill., In the middle of the cover.

For stability, I made the legs of thermal glue.

We take the bulbs and glue to the lid itself in the shape of a triangle, as shown in the photo. The wires are slightly shortened. Degrease the cap in advance with alcohol.

In a pre-made hole, we conduct the power cable from our unit. And solder all the wires.


Here is the connection diagram itself, resistors are NOT NEEDED.

We screw the jar into the lid, and we get a table night lamp for your children.
0
0
0

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose
4 commentary
And besides aesthetics ... These bulbs are heated quite strongly (in such old garlands, the cartridges were often either fused or cracked due to the drying out of the plastic). In a hermetically sealed jar, there will be heat in a few hours. "Hot melt" will flow .... Chinese postings inside the banks (which are from light bulbs) I would not warm up all night either ...
Cool, I imagined how this inverted jar would look in a children's room or bedroom. The master class, of course, is original.
As for the article .... Then again, many thanks for the high-quality connection diagram !!! And especially - for the information that the bulbs do not need resistors ... smile
Forgive me, but I would not leave this nightlight on all night ....

We advise you to read:

Hand it for the smartphone ...