» Antennas »Antenna for do-it-yourself FM radio phones

DIY antenna for FM radio phone


Greetings to all visitors to this site !!!
Sometimes we want to take a good rest from the TV, lie down or sit listening to the radio through the phone. But for some it happens that there are no headphones that serve as an antenna for an FM radio phone. And this one homemade - Antenna for FM radio phone, can help with this problem.

To build the antenna I needed:
1) TRS output from old broken headphones
2) Copper wire
3) Office knife
4) scissors
5) Soldering iron
6) Pliers
7) Insulating tape.


We clean the copper wire from insulation with the help of an office knife.

When we get the wire, we divide it into two parts with the same number of wires in each part.




Using a soldering iron, we cover both wires from beginning to end with lead-tin solder.



One of the wires is cut into two equal parts.

With pliers, we bend the ends of all the wires at a right angle.

Solder the wires to the TRS output, as shown in the photo:




We insulate the wires with electrical tape.


With flat-nose pliers we unbend short wires and get a shape resembling a butterfly.


Next, solder them together.

We bend the long wire like this:


Now solder it to other wires.

That's all, the homemade antenna for the FM radio phone is ready !!!

In my case, the antenna worked well, without any interference, it was only necessary to tune the radio.

That's all for me !!!
Good luck to all!!!
Bye everyone !!!
5.3
4.8
3.8

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose
4 commentary
Kutyrin Yuri Stepanovich NN
In order to listen to the FM station in Nizhny Novgorod, I bought a push-button cell phone for 500r texet TM128. It works for me without a battery (from a stabilizer 4.1 V), without a SIM card and headphones. I soldered two MLT-0.5 resistors of 47 ohms each to the Chinese (unfortunately) plug, the phone first cursed very much (“turn on the headphones”), but then I wrapped the plug with a blue electrical tape directly through the buttons and the screen to the phone and it worked, ears from resistors are a good antenna. Then I soldered two ends (3 meters from the old razor, without a screen) to one resistor and connected it via a five-pin connector (pins 2-3) to the Radio Engineering U 101 stereo amplifier through any 200 mv input.11 speakers are connected to the amplifier in one socket, connected in series, about 50 ohms in total. They are placed throughout the apartment. Since the TM128’s automatic frequency adjustment is excellent, everything sounds at the highest level (if there are fewer speakers, it will be louder). I adjust the volume directly in the phone (two lower buttons). Auto-tuning is turned on after selecting “Radio”, pressing the center button and after 3s it up.
If the Chinese three-pin 3.5mm plug does not come in contact or crawls out of the socket all the time, then you need to lay a cardboard washer (select the thickness), and then fix it with electrical tape. Twist the plug, leave the phone on a soft towel, if the contact does not disappear, it will work for 100 years.
Read my poems on poems ru. I never had a smartphone, I can’t say about it. With a smile Kutyrin Yuri NN.
Stunned, details from UAZ fit the phone?
Hello from the 90s!)
"Everyone has known since childhood: a thing wrapped in blue tape will last forever."
I will remain modestly silent about the rest.

We advise you to read:

Hand it for the smartphone ...