Hello everyone, dear visitors of this site. This time I will show you and tell you how to do it in home conditions homemade soap dish from a bottle of shampoo for hair. A soap dish is an inexpensive but very useful accessory that helps maintain order in the bathroom. Want to get an exclusive soap holder made by do it yourself? If yes, then this article, I think, will be useful to you.
And so, For the manufacture of homemade soap dishes I needed:
1) Glue gun and hot glue,
2) Electric drill,
3) Pliers
4) scissors,
5) stationery knife,
6) the hammer,
7) Two small cloves,
8) Marker.
1) A plastic bottle for shampoo.
Open the bottle. Put the lid aside, but we still don’t throw it away, it will come in handy for us.
We begin to peel the glued stickers from the bottle.
After removing the labels, sticky marks may remain on the bottle. This is the adhesive remaining from the stickers. You can use one of several methods to remove a sticker mark. But you should take into account the peculiarity of the material on which the sticky stain is located, since some cleaning methods are not suitable for all products. In my case, the material is plastic, and for such surfaces, a way to remove the sticker marks with vegetable oil is more suitable. In this case, you need to moisten the cotton pad or the edge of the rag with oil and rub the stain with an effort. Soon, sticky villi will begin to roll into larger spools and completely disappear from the surface of the product. This method can only be used after removing the top paper layer from the sticker. The easiest way to do this is by pre-softening the paper with hot water.
Next, take a sharp clerical knife and cut off the top of the bottle.
Also cut off the bottom of the bottle.
We align uneven parts with scissors.
We cut the resulting base into two parts.
Align uneven spots again.
Now mark the following marks with a marker.
By marks cut holes with an office knife.
We do not throw out the obtained two parts and cut another one, which coincides with the long of the three parts.
The resulting four parts are glued to the base on which the soap will lie.
These protrusions are needed so that the soap does not slip and fall from the soap dish. To make them the same, I painted them with a green marker.
With pliers we bend one side of the resulting base.
We round sharp edges with scissors.
We take the other half of the bottle and also bend one side with pliers.
Cut off the extra half of this part.
We glue the two parts together as follows.
Now cut two strips from the bottle cap.
We cut two rectangular holes along the edges of the stand so that the two past strips fit into them.
We bend the tips of two strips.
We insert and glue the strip with a glue gun into the previously obtained holes.
Glue the second one as well.
Using a drill, drill two holes on a soap box.
That's it, the homemade soap dish from the shampoo bottle is ready. Now you need to nail two small cloves near the sink and hang our soap dishes on them.
And this is where I end the article. Thank you all for your attention! Bye everyone!