I offer you the manufacture of a very simple and cheap in the manufacture of stands for the feeder rod.
We need only an empty tube of silicone, or liquid nails, sealant and the like ...
Strip of aluminum, about a millimeter thick.
Cut the nose off the tube.
I cut an aluminum strip from 4.5 cm to 5 cm wide.
In my opinion, it remained from the cover of old washing machines, such as RIGA, etc.
Unforgettable about processing the edges of the plates with a file.
Tightly tighten the tube with a strip of aluminum, as tight as possible. We bend the ends to the sides.
To get something like a clamp. The calculation is that the clamp fits well on the tube, and at the same time it can be removed.
Let's take a peg for the stand.
I took the same strip of aluminum and bent at an angle of 90 degrees along the entire length.
You can also take a factory aluminum corner, 25 by 25 mm. But I did not have it, I had to make it.
Trim with a hammer on a flat surface.
We cut the corners about five centimeters on each side. This will be a pin for fixing in the soil.
Then we make small slots on the flat end of the pin so that it is easier to bend the plates together. For fixing with a clamp.
Now flatten the side plates along the edges of the bends of the clamp.
Using a rivet, we fasten both parts.
Cut the hacksaw at the metal at an angle, the excess tube. With the expectation that at the upper point the depth of the tube should be 13 cm, and at the bottom 7-8 cm.
This is for the convenience of pulling the rod from the holder.
Now, simply by turning the clamp, you can either prepare or assemble the stand in the stowed position.
Good luck fishing !!!