To make a knife do it yourself, the author needed.
Canvas from a mechanical saw (r6m5), a piece of wood, angle grinder, emery, epoxy glue, sandpaper with different grain size, 2-sided adhesive tape and a little patience.
The author took the blade from the saw,
on a plain sheet of paper, he painted the shape of a knife, put the drawing on the canvas and outlined. 2
Then, using angle grinders, I cut the workpiece with a margin.
On an emery, he adjusted the contour of the knife by grinding off excess metal.
Then he took the tape and glued it to the emery stone,
and glue sandpaper on top of the tape
and cleaned the blade from rust.
Then, with the help of a file and an emery (without a handyman and any adapt), he began to make descents
Then he cleaned it up with rough sand paper (60).
Then he polished with sandpaper with different grain sizes.
Then the goy paste was applied to the felt circle.
and polished
Then he went to the hilt itself, took a piece of wood
made a block out of it with a knife
with a marker on it painted the shape of a future pen.
The author took a brass plate as a bolster
cleaned it and cut a piece
measured out the center
drilled holes for the shank
that's how the author got it
he wrapped a knife blank with electrical tape
next, he took an aluminum tube
to press the bolster onto the shank and hammered it.
in the bar he found the center and began to drill
By tape with a drill, the author noted the depth of the hole
he also took a piece of skin
now everything is ready for gluing
glue and hardener he mixed well
and glued
left everything in this position for a day
Then with a knife he removed some wood from the handle
from sandpaper cut a circle on the end of an emery.
Then he began to form a handle
Further, the author polished the handle manually
using sandpaper of different grain sizes.
Here is the result of the author.
In the future, the author will impregnate the handle with linseed oil.