Modding of computer cases, flash cards, phones is mainly done with the use of metals such as brass and copper, their combination looks very good against the backdrop of the latest developments in science.
The main task of modding is to change the hull, to make rationalization changes to the design. Basically, young people are interested in this, because everything new is interesting to the younger generation.
The main role here, of course, is played by uniqueness and manual work; all this is in demand and respect. The author has long been engaged in this direction and gained considerable experience, which he kindly shares with the people.
And so, let's look at what exactly will be needed to create a flashcard case in the form of an old lamp?
Materials
1. 0.5 mm copper sheet
2. plexiglass
3. copper wire
4. brass sheet 0.5 mm
5. 16GB flash drive
6. wire
7. colored glass
8. epoxy resin
9. solder
10. soldering acid
11. LED
Instruments
1. drill
2. file
3. sandpaper
4. ammonia bath
5. hammer
6. wooden doodle
7. pliers
8. tap
9. die
10. burner
11. vernier caliper
12. metal scissors
13. GOI paste
14. velvet
15. hacksaw
Step-by-step instructions for creating a flashcard case "Flashlight" do it yourself.
It all started with the fact that the author saw on one of the sites devoted to antiques and objects, an amazing-looking kerosene lamp made of brass. The master immediately decided that the flash drive would be of this form, though with minor modifications, but it was this flashlight that was taken as the basis.From the scraps of copper tube from the air conditioner remaining after the previous work, the author creates a case. He takes the necessary section of the tube in size, puts it on a wooden block and with the help of a hammer flares the edges.Here is a form obtained.Saw off a brass tube.Also bends such details.View from above.All parts are assembled in a heap before soldering.The author begins to solder sequentially.The next detail.Soldered with a simple solder using soldering acid.Twists the parts before soldering with a thin wire.Place for installing flash cards.The flash drive itself.With such a tiny size, it has a memory of about 16 GB.Then makes the mount.Sets the LED.Collects.I inserted a flash card into the case.Something like this.Slightly pale)The main thing for Modding is of course the body kit. The master decided to add a valve of this shape.He took a piece of copper.Drill and file made such a detail.I cleaned it with sandpaper.Just made a mount.I drilled a hole in the case.Cut the thread.He twisted the valve into place.Makes a cover.
This concludes the article. Thank you very much for your attention!
Come visit often, do not miss the latest in the world of homemade goods!
This article is for informational purposes only!