As a basis, the author took the substrate from the notebook; they can be replaced with thick cardboard.
Attaching a substrate to the phone, the author cut out blanks for the case, not forgetting to make holes for the speaker and camera.
Having made such blanks.
The author placed them on a piece of leather and circled a pen with a margin of 1 cm.
And cut it out.
Then I glued blanks No. 2 and narrow to a piece of cut leather.
And on the front side of the cover where the blank under No. 1 will be located, the author will emboss. To do this, he printed a drawing of future embossment and transferred it to a piece of substrate.
And cut it out.
Then glued it to workpiece No. 1.
The skin in the place where the workpiece will be glued, the author abundantly moistened with alcohol from the back.
Then he applied glue to the workpiece and glued it into place.
Then, on the front side where he wetted with alcohol, he began to push the embossing well.
Using at the same time improvised tools.
Such an embossing happened to him.
Then he pasted the last blank.
Then the author missed all edges with glue and bent inward.
In the corners, before bending, the author cut off the excess skin so that there were no wrinkles.
Then he cut holes for the camera and speaker.
Having missed with glue, he bent these places inside.
Further, the author rounded the edges between the first and third blanks.
Then he took another piece of leather for the inside of the case.
Putting the cover on it, circled the handle along the contour and cut it out.
To store cards, the author, attaching a card, noted the places for slots for them.
The author made the same procedure in the middle part of the cover.
Then he made a slot with a knife.
In order for the top cards not to fail, the author took two pieces of thin fabric.
I inserted the card into the slot, fixing it with a paper clip, he marked the places where thin tissue would be glued.
Then he took out a card and glued one edge of the fabric below the slot.
And he glued its second edge above the slot.
He did a similar operation in the middle of the cover for the top card.
Under the bills, the author cut out such a pocket from leather.
Then, on this pocket with the help of a needle and a ruler, the author made holes with an interval of 3 mm. In order to be able to flash the pocket smoothly and without much difficulty.
Then he took a kapron thread.
I cut a piece from it and threaded both ends into needles.
And he began to sew as shown in the picture.
Then the author glued small neodymium magnets in the indicated places.
Further, the author cut off two identical rectangular pieces from the skin, and first glued them together, and then stitched them. It will be a clasp.
In order for the clasp to stick to the magnet, the author put a piece of metal plate bent in half on the edge and pressed it on the clasp.
The author says that you can use another option, to make a fastener, insert a magnet.
After the author tried on a clasp.
And proceeded to the inside of the cover. From the beginning, the author applied glue along the edge of the cover and on only one part of it.
Then I glued the skin cut out earlier and the corner that he was stitching.
Then he made holes for the seam.
And I asked him.
Similarly, the remaining parts first glue then holes and only then sew.
Mounts for the phone can be made from pieces of elastic as shown in the picture.
But the author used fastenings from his old case. He just stuck it.
And such a purse-case came out from the author.
According to the author, the capacity of such a cover is four cards and up to ten bills, and of course the phone.
Thank you all for watching, I hope you enjoyed it. Until the next article.