» Topics » DIY ideas »Centers for the assembly of paneling furniture

Centerboards for the assembly of panel furniture

To add (drill) shields with a drill for assembly on dowels, I suggest using centrics. When drilling the shield end, the drill is usually shifted from the mark.
The centrics are tightly inserted into the holes drilled at the end of the shield, the assembled shields are positioned among themselves, after which the pressure on the shield with the eccentrics is applied. On the face of the second shield there are clear prints from the centrics, through which holes are drilled on the second shield, which are obtained "in place".


In the kit you need to have 4 pieces. Important: the centric hats should protrude beyond the edge of the shield so that they can be grabbed with pliers, the tip should be 2-3 mm high, with higher shields it is inconvenient to position the shields with each other.
Question \ topic is automatically published in the social. site network - stay tuned for answers there:

Suitable for topic

Related topics

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose

We advise you to read:

Hand it for the smartphone ...