Soldering is an integral part of the repair and manufacture of all kinds of electronic equipment, and smoke from fluxes and lead vapors have a negative impact on health, especially if their exposure occurs on a regular basis. This desktop hood can help to cope with this problem. It significantly reduces the level of smoke and odors when working with a soldering iron or hot air gun. Works device quietly. Its back is equipped with slots located at an angle, due to which the air goes up, and is not reflected from the nearest surface. The hood is switched on and off by means of the toggle switch. A corrugation can be attached to the back of the hood (having bought a special adapter or having made its analog) and brought it, for example, to the street. Note that during the first few days, the smell of burnt insulation may be present, but later it disappears. To achieve the best smoke absorption, it is recommended that the working surfaces be placed closer to the exhaust hood. The hood design allows you to tilt the air intake
The characteristics of the device are as follows:
• voltage: 220 V (adapter for Euro plug included);
• power consumption: 16 W;
• absorption rate: 0.93 - 1.07 m3 / min;
• material: plastic + metal;
• size: 195 mm x 285 mm x 143 mm (width x height x depth);
• weight: 1056 gr.;
Included with the hood itself are 3 carbon filters (main and two spare). It is recommended to replace the filters once a month or with a noticeable dusting. Carbon filters for these hoods are widely represented in Ali, so there will be no problems finding them.
Cost: ~ 1273