We offer you a simple and reliable way to create a leash that can be made in a few minutes without any special conditions.
To do this, we need the following tools:
Step 1.
Tie a regular knot
Step 2
We insert the free end into the node, it must be directed so that it turns out a loop.
Step 3
The free end must be threaded in. Put on the loop.
Step 4
Next we pull the knot (see photo). But the knot is not fully tightened.
Step 5
This is most conveniently done with a clamp. See photos
Step 6
So, we have to get a knot and a loop, we cut the remaining free end.
Step 7
As a result, we should get a knot and a loop. We cut off the free end.
Step 8
As a result, we have formed a knot with the necessary loop. Having trained, you will tie fluorocarbon without problems! The product created by your hands does not lose its characteristics and is not noticeable in water at all.