Given device very useful in cases where the tin lid on the can is not unscrewed. To make such a tool, you will need very affordable materials that we usually throw away. Despite the simplicity of manufacture, this tool is in no way inferior in functionality to the analogous one made at the factory, and having made it do it yourselfYou will enjoy and save your money!
To make such a tool, we need:
- Five liter plastic bottle
- Piece of reiki
Homemade making
To begin with, we clamp the rail in a vise and saw off the excess part from it, leaving a 15-20 cm length in the vise.
Then, with a marker or pencil, mark the oblique line as shown in the photo below.
Next, armed with a hacksaw for metal, we cut obliquely the end of the rail, at the mark.
Then we process the sawn surface well, removing roughness.
Next, release the workpiece and turn it over the opposite side and again clamp in a vice.
Then again we make the markup in the form of a line, just like on the other side. The mark must be made a little further than the one that was on the other side.
Next, we make a cut with a hacksaw for metal to the mark to the middle of the rail, as shown in the photo below.
Then we cut off the ring from a five-liter bottle.
Fold it in half and cut off a little more than half with scissors.
Now you need an ice cream stick or something similar to it, the main thing is to be thin, about the thickness of the sheet of metal.
Fold the cut strip from the bottle, put the end to the slot and press it out, hammering a thin stick, as in the photo below.
Then, with a drill, two holes must be made to fix the plastic strip.
Well, to twist there two screws. Holes must be made necessarily, since if you tighten the screws without them, the rail can crack and all the work will be worthless.
Well, our tool for unscrewing the covers is ready.Using it is very simple, just put a plastic ring on the lid and unscrew the lid with a lever. The tool is very convenient and takes up little space in the kitchen, but at the same time it is incredibly effective.
As you noticed, the plastic strip must be installed so that the resulting ring could easily be put on the cover. That's all, thanks for watching! )))
Video fixtures: