In order to collect such homemade.
The author took a profile for attaching drywall.
I made one meter markup.
And snapped.
Also, the author took four cartridges e27. Such cartridges are often used in table lamps and other lighting fixtures. But you can take any other cartridge, the main thing is that it be with a mount.
At the same distance from each other, the author noted the location of future holes for attaching cartridges.
Made holes.
For each cartridge, the author connected a small piece of wire of 2.5 squares.
Since this lamp, he will use it also as a small heater.
Using bolts and nuts, he attached the cartridges to the profile.
After connecting the edges of the wires.
Using a terminal block to connect the wires, he connected to the wire that will go through the switch to the network.
The author used masking tape as a dielectric.
He fixes the connector on the profile using a self-tapping screw.
The self-tapping screwdriver cap was a little bit grinded, as it prevented the lamp from being fixed.
You can fix the lamp using a punch and a drill for concrete.
But the author decided to fix it with liquid nails on a rubber basis. To do this, he first degreased the profile with a solvent.
Then he applied glue and let it dry for five minutes.
After glued the lamp to the ceiling.
And set the spacer until the glue hardens completely.
According to the author, one hour later, the glue had already set and the homemade work could not be torn off. The author screwed in light bulbs.
And he began to test the performance of the finished homemade product.
Everything works.
According to the author, such a lamp can be made up to 3 m long and not four lamps can be installed on it, but much more. After all, incandescent lamps, 90% of the energy consumed are converted into heat. Thus, it can be used not only in the garage or a workshop, but also in other rooms, such as a chicken coop or a pigsty.
That's all. Thank you all and see you soon.