» Homemade homemade »Illuminated fountain

Illuminated fountain



An interesting fountain was made by the Master from acrylic. Such a fountain will serve as a good decoration of the room and can be used as a night lamp. To make the fountain, the master used the following
Tools and materials:
-3 mm acrylic sheet;
-Pump 300 W 200 l / h;
-LED strip IP65;
-12 V power supply;
-A tube;
- Paint tape;
-Electro wire;
-Plastic capacity;
-Silicone sealant;
-Super glue;
-Glue gun;
Epoxy resin;
-Soldering iron;
-Drill;
-Scissors;
-Knife;
-Aerosol paint;
-Decorative palm;
Step One: The Case
First you need to cut out the details from acrylic. Cut four strips 46 * 10 cm, six small strips and three squares.
Lays four stripes in a row. Glues masking tape on top and bottom. Glue four strips on one side. Two more acrylic strips stick on the other hand.







Folds the box and fixes with tape.

Drills a hole in the bottom cover.


Step two: wire
An incision is made into the tube and the wire is drawn through it. The incision site is sealed with epoxy. Puts the phone from the bottom to the top. Glues it with silicone.





Glues the middle cover by first extending the tube with the wire into the hole. The lid is glued into the inside of the case and rests on glued plates. A soldering iron burns several holes in the lid.




Step Three: LEDs
Cuts four pieces of LED strip. Solders to the contacts of the wire. Sticks two strips on the top cover. Paints the top side of the cover. Connects wires to the connectors and glues the cover.








Step Four: Bottom
Installs a plastic palm in the case. Glues the bottom cover. Sticks on two LED strips on the cover (secures with electrical tape). A pump is connected to the tube (through which the wire is drawn). Connects the wire of the power supply, motor, LEDs. Seals all connections with hot melt adhesive.








Illuminated fountain

Step Five: Scenery
Pastes over the top of the case with paper with a pattern.


Step Six: Capacity
It places the fountain in a plastic container, pours water into it and turns on the power.






All is ready.

The whole process of making the fountain can be seen in the video.
10
10
10

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose
1 a comment
As far as I understand, the pump delivers water upward, and from above it pours gravity? Then this is not a fountain, but a waterfall! smile

We advise you to read:

Hand it for the smartphone ...