In this article, we will look at how the Master made an interesting lamp above the bar counter of his basement from wine bottles.
Tools and materials:
-Board;
-Plywood;
-Bottles;
-Drilling machine;
- Forstner drill;
-The wire;
-Electric cartridge;
- Joiner's glue;
- Stain;
-Polyurethane varnish;
-Sander;
Milling cutter;
- Clamps;
-A circular saw;
-Tile cutter;
-Sandpaper;
-Roulette;
-Marker;
Step One: Tray
Wine bottles will need to cut off the bottom. To hold the bottles during cutting, the master makes a tray of plywood. The length of the tray is equal to the length of the bottle.
Step Two: Cutting
Before cutting, you need to clean the bottles of labels. The master soaks the bottle in a bucket of water, and then removes the labels. Sets the bottles in the tray and cuts off the bottom.
After cutting, polishes the cut edges.
Step Three: Suspension
The master makes a suspension from plywood. Slices plywood marks the installation sites for five bottles. Drill holes.
Step Four: Install Electric Cartridges
Using special device, the master sets the cork in the neck of the bottle. In traffic jams drills a hole. A wire with a cartridge at the other end extends into the hole.
Step Five: Box
Now you need to make a box around the suspension. The master marks and cuts the board. Frezoy cuts a groove. Boards are coated with stain and then varnish. Collects a box.
Step Six: Build
Inside the box, two bars are screwed along the edges. He pulls wires into the holes and hangs the bottles at the same distance from the suspension. Between the bars secures the mounting box. Connects wires.
Seventh step: installing the lamp
The master hangs the lamp from the ceiling using a chain.