Today I want to tell you about how to make a homemade water tap ...
To begin, I bring to your attention a video of our homemade:
[media = http: //www.youtube.com/watch? v = lJn5vmDVSWI]
In this article I want to tell you about how to home conditions without making special efforts with the help of improvised means to make a homemade water tap ... This device can be used in the country or in the garage... A convenient enough fixture to, for example, wash your hands or rinse any small container ...
So, let's begin...
In order to make this water tap we will need the following:
- canister or unnecessary capacity (preferably at least 5 liters);
- a small piece of hose;
- a syringe;
- drill and drill ...
So, first, gently cut off the top of the syringe as shown in the photo ...
Next, using a drill and a small drill, we make 3-4 holes along the entire syringe ...
Now also with the help of a drill and drills we make a hole at the bottom of our canister or other container of your choice ... The hole in diameter should coincide with the diameter of the hose ... Next, gently insert a piece of hose into the hole in the canister ... Make sure that everything is hermetically ...
Now we insert a syringe into the hose and also make sure everything is tight ...
Well, that’s the principle! Our device is ready !!! Now we pour water into the canister, substitute the bowl and see what we get ...
Piston in the syringe regulate the flow of water: if the piston is slightly extended, water will flow from one hole ...
If you pull out a little stronger, then the water will come from two holes at the same time ...
And so, as you stick out the piston of the syringe, you will regulate the flow of water, that is, if the piston is pushed out as far as it will go, the water will “go” right from the four holes in the cylinder of the syringe, which we have made, and if put the piston back, then the water will stop "going" at all ...
So today I introduced you to a homemade device ... a water tap ...
Good luck ...