Hello! In this article I want to talk about how you can make a convenient body for solder. My solder is wound on a reel and accordingly it is not very convenient to use. And I got the idea to make a case that could freely lie in my hand.
To make this design, we need:
1) solder
2) pushpin or some sharp object
3) some cylinder, I used an ordinary felt-tip pen
4) and, of course, the case itself (preferably small so that it fits in the hand)
Assembly
Step 1.
To get started, let's get some solder. We take the cylinder and carefully wind the solder.
Carefully remove the solder from the cylinder. We get such a spring.
Step 2
In the lid from the case, we make a hole in the middle with a clerical button. And we check whether the solder passes through the hole, if with difficulty, then you can make an additional hole.
Step 3
Then we take the end of our spring and thread it through the hole in the cover.
We close everything.
Here we have it homemade. The decency of all components of this homemade product can be done in 5 to 10 minutes.
Thank you all, good luck to everyone !!!