» Topics » DIY ideas »Lathe coming out soon

Lathe coming out soon

Topics / DIY ideas
Added 1 a comment
Hello to all those who visit this site so often. At this stage, I have an almost finished woodworking machine assembled in the previous couple of days. I ask you to help me in solving the problem with fiscal tailstock, if in detail, then the tailstock moves in grooves that are made in the guides mounted on the frame with screws.

And the other day I will post material, I hope you enjoy it. Thanks to all.
Question \ topic is automatically published in the social. site network - stay tuned for answers there:
3
Added 1 a comment

Suitable for topic

Related topics

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose
1 a comment
0
Reply To quote A complaint
1. On the edges of the back "headstock" screw the corners (steel, duralumin). In the corner holes, fixing screws to the side rails.
2. Lengthen the upper boss over the entire width of the headstock. Fasten (glue) 2 nuts (~ M8) inside the boss. They tighten a sharpened long bolt (M8) - the rear center. Locking nut (3)
3. Close the electric motor with a cover (plastic, tin ...), as the dust-shavings will clog all the holes, etc.
4. Tool guides (preferred)
5. Switch (electric fuse)

DIY categories

We advise you to read:

Hand it for the smartphone ...