Hello! the inhabitants of our site. The tanning season is no longer tanning and the first problem that arises is not enough moisture in the room. Since heating radiators drain the air in the room. And a humidifier in the heating season is a must. Well, a homemade humidifier is not inferior to a purchased humidifier and this can be seen as a result. And the cost will be much cheaper.
Today I will describe to you how to make the most primitive and simplest room humidifier.
We will need:
1) Tara.
2) Two liter bottle.
3) Paul liter bottle.
4) Connectors female 5.5 mm 2 pcs.
5) Connectors male 5.5 mm 2 pcs.
6) Coolers 2 pcs.
7) Glue.
8) Self cuts 4 pcs.
9) Ultrasonic atomizer.
10) 24V power supply for the atomizer.
Assembly:
1) The author took a plastic container as a container. And to begin with, we will make a hole in the lid of the container under the large bottle so that it tightly enters and does not pass the escaping steam.
2) Next, cut out the holes for the cooler and two mounting holes on top so that water does not leak.
3) Now we make a hole for the wire from the sprayer, so that the plug on the wire fits tightly.
4) We fix the coolers on the cuts themselves and connect them in series to the mother connector.
5) Then we make a hole with a slightly smaller diameter than a small bottle.
6) Cut the bottom of a small bottle. And now, using two component glue, glue the bottle to the container lid. Glue that is slightly preheated can be used, since hot plastic glue can cause the plastic lid of the container.
7) Next, we pour water into the container in our case, 4 cm.
8) Make a small hole with a soldering iron, as shown in the picture.
9) Take a large bottle and close the hole with your finger and pour water, and then close the lid. Put the water bottle in the container by releasing your finger.
10) Let's make a splitter of two connectors father and one mother. In order to connect the atomizer and cooler from one power supply.
11) Everything is ready.
Total:
Optionally, you can connect a switch, a backlight or a humidity sensor on an arduino.You can also use two or even three sprays to increase power. Accessories can be found on Ali. As a result, we got the simplest room humidifier, which is not inferior in performance to cheap factory humidifiers.