» Fixtures » Machine tools »Mini DIY drilling machine

DIY mini drilling machine


Consider how the author made a simple mini drilling machine.

Instruments:
Drill
Angle Grinder
Grinding machine
materials
Hacksaw
Pliers

We make the base of chipboard

DIY mini drilling machine

We drill two holes in the base (with a distance of 12 cm between the holes) we fix the guide tubes.




1st hole 54mm from the edge of the tube and 2 holes 73mm from the edge of the tube.
We drill holes through.
We attach the tubes to the block.


We make two identical marks at each end of the block and connect them.




We mark the place for the steel bracket ideally.

We drill holes and attach the bracket.


Tighten the hook spring screw on the back of the wooden block

Cut a circle with a hole as in the photo.

Grind the rough edges of the circle.
We make a groove for steel wire.
We drill holes in the circle for the handle.
We drill a hole in the right side of the wooden bar to fasten the circle.
We use a screw for fastening.
We drill a hole for steel wire.
Set the handles.








We install dowels sliding inside the pipes and fastening a wooden beam.





Steel wire 16 cm long + twisted ~ 4 cm at each end.










If there is no suitable spring, rubber can be used.
The result was a mini drilling machine. Good luck to everyone homemade.
4.8
3.5
4

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose
2 commentary
Not to them, money must be earned.
We mark the place for the steel bracket ideally.
Screw the hook spring screw
We install dowels sliding inside the pipes and fastening a wooden beam.
Steel wire 16 cm long + twisted ~ 4 cm at each end.
After the auto-translator, didn’t come up with the idea to check that he messed up there?

We advise you to read:

Hand it for the smartphone ...