I made these swings just to sit and think about everything that is happening in our world))) Well, without it, just so that there is no void on the site.
Instruments:
1. Electro Planer.
2. Screwdriver or drill.
3. Pencil and tape measure.
4. Drill. (Suitable for bolts)
Materials:
1. Board. (In sizes what you need)
2. Bolts with washers 4 pieces. (Long so that it went through the board and there was still about 5 cm)
3. Chains 2 pieces.
4. Bolts 2 pieces. (needed to hold the chain together at the top)
5. The iron bar. (sturdy and straight)
6. Two trees (which are opposite each other and also that they have knots that must withstand heavy weight)
Well, if you have it then we start to do it.
1.Step. We put an iron bar on the trees and fix it. (I did not fix it as it was not necessary)
Step 2. Now we throw both chains on the crossbar and align them.
3.Step. Now we make a board. We take an electric plane and cut off the corners on the board and work on it (on the board). (It is better to use a grinder)
4. Step. We measure the places where there will be holes for the bolts. I stepped back from the edge of 50 mm. It is necessary to drill 4 holes from all angles. We drill.
5. Step. We fasten the board and chains with long bolts.
6.Step. From above, we also fasten the chains together with short bolts. (Well, or you can fasten the chains in any other way so that they do not go there-syudy)
Well, that's all the swing is done !!! Well, maybe you don’t swing well on them, but you can sit.