» Country homemade »" Well "from tires with their own hands

Do-it-yourself "well" from tires


I saw such beauty on the Internet and decided to try to do it. I did it myself, I didn’t buy anything, I came up with what to do on the go, everything unnecessary went into business, so do not judge strictly!

For work you will need:
Tires - 3 pcs.
Roof decking
Screws
Screwdriver
Board for racks - bar 60 * 40
Profile for drywall 40 * 20
Hand saw
Plastic bucket
Chain (small length)
Brown paint
Black paint
White paint
Wooden bar of a crossbeam (from an old wooden crib)
Brushes
Roulette
Scissors for metal
Bulgarian

First, take three tires of a suitable size and thoroughly wash them.

Then, after the tires are dry, with a screwdriver we fasten 2 tires from the inside with a screwdriver, 2-4 screws will be enough.

Then, in the third tire, we cut openings with a knife, approximately the size of future racks. We put on the connected tires and also fasten with screws.

Then we take the beam, the length of my beam was 190 cm, I divided it into 2 equal parts of 95 cm and inserted it into the slots.


Then she fixed the beam to the tire with screws.


After I found another beam, it was probably about 70 cm long. I put it on the racks and “screwed it down”, this will be the basis for the roof.


Then she took the bar from the crib, measured the internal distance between the racks and sawed off the desired piece.
Then fixed on racks with self-tapping screws.


Further, the remaining segment from the plank was divided into three unequal parts and “blinded” such a twist! And fixed with screws with the crossbar.



Roof. I took an unhealthy section of the profile for drywall, with metal scissors I cut it into 4 different parts. She made small cuts on one side, and cut corners on the other. She attached the cut parts to the racks and bent a little out of the slope of the roof and fixed it on the sides with self-tapping screws.


A small section of the corrugated board was cut by the grinder into 2 equal parts and screwed to the transverse beam and profile with self-tapping screws.

Before painting, the crossbar had to be moved a little higher.
And painting. The main color of my well is brown.White paint for ornament and black paint for twist.

It remains to wait until the paint dries and hang the bucket on a chain. Done !!!

Have a nice day and enjoy homemade!!!
6.4
7
5.8

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose

We advise you to read:

Hand it for the smartphone ...