Hello dear aircraft modellers.
For a long time I was going to talk about one amazing aircraft model, the prototype of which was the no less amazing aircraft of the times of the First World War.
From history why model so called?
A huge number of aircraft models created their aircraft models and copies, and half copies, and simply based on this triplane.
The model that I will talk about began to be created long ago, but everything that was done hung on the carnation in the author’s workshop for a long time.
But, here came the moment when the author’s hands reached, again, this model.
By this time, the ICE (Internal Combustion Engine) "Centurion" appeared at the author of the model, and it was possible to continue work on creating the model, fitting parts for it.
Fitting the engine to the engine mount made of durable 6mm. plywood.
4 mm aluminum blanks are made. for landing gear.
The author believes that this aircraft is a four-winged plane, since he has another small wing between the landing gears.
And so the spar of this wing is placed. Installation of the construction for fastening the wings of the model begins.
All three wings should be installed at certain angles to the horizontal plane, which will be used in front of the fuselage truss, in front of the cockpit.
Chassis racks are attached to the fuselage. A little bit of casing is done.
Installation of the lower wing begins.
All wooden parts are varnished.
The middle wing is installed.
The most important thing is to make the correct arrangement of the wings among themselves.
Side racks are mounted.
Checks the correct installation of the wings.
Each wing has the ability to change the angle of attack.
Photos of the wings, after varnishing.
Installation of servos and aileron hitching begins.
This is how the upper wing looks in the final version.
The tailing work begins.
The keel rotation device.
Mounted hogs.
Work on the creation of a stabilizer and a hitch elevator.
A rear crutch is installed.
Cloth model started.
A few photos before the final close-fitting model. models.
The model CT, after verification, coincided with the calculated one.
Work on creating a hood for the engine.
The pilot's seat is being made. Trying on a pilot figure.
The close fitting model. Painting and final finishing of the model begins.
Wheels are made and installed in place.
Identification marks are applied.
This is the model of Red Baron.
Photos of the first flight.
Video of the first flights.
Dear friends, this is where I end my story. See you again. IN..