This handle greatly improves the usability of both the original dremel (models 100, 200, 275, 285, 300, 395, 398, 400, 800, 3000, 4000 and 8200), as well as its Chinese counterparts. So, the accuracy of work and the positioning of the tool on small parts are increased, and a hand with such a grip gets tired much less. The handle is made of high-quality plastic, rubberized at the grip points, due to which it does not slip at all during operation. In addition, it is equipped with stiffeners, eliminating its bending and increasing the resistance to play. The handle is equally convenient both when working in the longitudinal axis - for example, grinding, working with engraving nozzles or drills, and in the transverse when working with cutting wheels. The price of this pen differs from the original by more than 3 times!
On the engraver, it is tightly fixed with a plastic nut with a thread, the hole itself in the handle, worn on the engraver, is not equipped with a thread. Due to this type of fixation, it becomes possible to install the handle as you wish along the axis fixtures. On some models of engravers, there may be a gap between the body and the handle, which means that backlash is inevitable, so refinement will be required. On the Internet, two ways to solve this problem were discovered: cut the gasket and place it in the gap, and more radical - cut the landing ring and fix the handle on the engraver body with self-tapping screws (this method frees the landing thread). Note that judging by customer reviews, the handle sits perfectly on Chinese engravers.
Cost: ~ 207