This short article will tell you how to expand the functionality of a circular (circular) saw. Easy to manufacture device make a miter saw out of it. Modernization does not directly affect the saw, and it can still be used as a disk.
Tools and materials:
-Circular Saw;
-Lumber;
-Nails;
-Hammer;
-A screwdriver;
-Royal loop;
-Fasteners;
-Ushm;
-Petal circle;
-Coating;
Step One: Foundation
First, the master makes the foundation, as in the photo. The height of the walls of the base is 5 cm, the length is 60 cm.
Step Two: Desktop
Next, the master makes the desktop. A circular saw will be installed on it. The desktop is attached to the base with a piano loop. Those. it can be raised, put the board and lowered into place.
Step Three: Guide
Next, you need to make a guide. The master makes a cut through the surface of the desktop and the side walls of the base exactly at an angle of 90 degrees.
Step Four: Cover
The master cleans the angle grinder with a petal circle and covers it with oil.
All is ready. Now the master will always be able to cut the board precisely with the sides of 90 degrees.
The whole process of manufacturing this simple but useful device can be seen in the video.