In this article, we will talk about a homemade device for turning wooden spoons. And show us how to make this homemade, author of the YouTube channel "cemaL AÇAR". And also, the author will demonstrate how this homemade product works and make a wooden spoon.
Tools that the author used to work:
Angle grinder
Petal circle
Metal cutting wheel
Marker
Square
Roulette
Rasp
Sandpaper
Vise
Clamps
Electric drill
Welding machine
Electrodes
Hacksaw for metal.
Materials:
Steel bar 10 mm in diameter.
Saw blade.
Wooden logs.
Not a big piece of wood.
And first of all, the author made the markup on the saw blade.
After that, inside this markup, the master made another one, slightly smaller than the previous one.
So it happened.
Then I cut the workpiece according to the first marking.
And corrected the edges.
After I found the center for this workpiece. And departing from the center by 4.5 mm in each direction.
He drew straight lines.
Like that.
Then he took the bar, and laying it on a round billet in the center, made marks along the edges of the bar 90 mm long.
After he cut the rod.
And in the middle of the bar he made a cut. For the first part.
Fitting.
Installation
Then the master, fixed the parts by welding.
After processed the seams.
And he turned the first part on the second marking.
Then he sharpened by the principle of sharpening a pen drill.
Here, in principle, and finished homemade.
Now the author will show how he will make a spoon using this fixtures. To do this, he will take a wooden log, and with the help of a hacksaw he will cut it along.
It turned out two blanks.
After, in the bar will make a guide hole, with a diameter of about 12 mm.
Next, clamp, fix the bar on the table.
Also, next will fix one of the wooden blanks made earlier, from which he will make a spoon.
Then it clamps one edge of the homemade product into the chuck of an electric drill.
And the second edge is installed in the guide hole.
And by pressing the drill start button, he makes a recess in the wooden blank.
After polishes the front side of the future spoon.
Then he draws with a marker the approximate shape of the spoon.
And a hacksaw removes all unnecessary.
After processing the workpiece with a rasp.
Then processing with sandpaper.
After processing with sandpaper, the author made a hole in the handle, for convenient storage of the finished product.
After soaking the product with oil.
Such a spoon, you can make do it yourself without any machine tools.
In the end: today, the author turned out two useful homemade products. I would like to say to the author, thank you very much! And wish him success.
And that’s all for me. Thank you all and see you soon!