Such a set of fasteners will definitely come in handy both when repairing all kinds of equipment, and when creating various kinds homemade. For example, it will be a pleasure to assemble cases using these screws and threaded inserts from this article. It should also be noted that these screws are designed to be installed in a “sweat” position, but due to a sufficiently small cone near the hat, if necessary, they can also be used where a similar fastener with a conventional hat is required. Carbon steel screws made. The black coating on the screws is quite resistant and does not peel off during the first installation.
The scope of delivery includes screws of the following sizes (thread diameter in mm x length in mm):
• M2 x 3 (20 pcs.);
• M2 x 4 (20 pcs.);
• M2 x 5 (20 pcs.);
• M2 x 6 (20 pcs.);
• M2 x 8 (20 pcs.);
• M2 x 10 (20 pcs.);
• M2 x 12 (20 pcs.);
• M2.5 x 4 (20 pcs.);
• M2.5 x 5 (20 pcs.);
• M2.5 x 6 (20 pcs.);
• M2.5 x 8 (20 pcs.);
• M2.5 x 10 (20 pcs.);
• M2.5 x 12 (20 pcs.);
• M3 x 5 (20 pcs.);
• M3 x 8 (20 pcs.).
This set is delivered in a transparent box made of high-quality plastic with a latch. Each screw size is located in a separate compartment. For convenience, there is a sticker-memo on the case about which cell corresponds to a certain size.
Thus, at a relatively low price, you will get a decent set of high-quality fasteners (300 pcs. In general, but there are times when the seller puts more) in convenient packaging, especially since offline sizes of less than M3 are sometimes quite difficult to find.
Cost: ~ 315