Walking in the store and examining the goods, I drew attention to the LED lamps ECO LED TB-10W-865-G13-600mm. Outwardly, they looked like fluorescent lamps of a lamp that was lying at my faulty home. I suggested that I could restore the lamp. I could no longer find fluorescent lamps for the lamp. And the new luminaires for ECO LED bulbs LED TB-10W-865-G13-600mm are not cheap, but basically the same as the old ones, they have the same body, lamp holders, diffuser. For alteration, it was necessary to remove unnecessary parts and connect the connecting wires in a different way.
Two ECO LED TB-10W-865-G13-600mm lamps were purchased by me.
Having returned home, I proceeded to remake the fluorescent lamp.
Old fluorescent lamp.
Disassembled fluorescent lamp.
Disassembled luminescent lamp with an LED lamp ECO LED TB-10W-865-G13-600mm.
I take off fluorescent lamps and a throttle.
I installed the LED lamp in the lamp holders with G13 socket.
I have to dismantle the starter holder.
The starter holder is dismantled. We proceed to the installation of the circuit.
Before that, I checked whether the LED lamps on the G13 socket are connected. To do this, I took a multimeter, set it to ohmmeter mode, connected the probes to the contacts of the G13 base. The resistance between the contacts of the cap G13 was 0.2 Ohm. It became clear that to turn on the ECO LED TB-10W-865-G13-600mm lamp, it is necessary to connect a phase wire to one of the G13 sockets, and connect the neutral wire to the other G13 socket. Based on this, I put together a circuit.
It remains to install the LED lamps and apply an alternating voltage of 220 volts.
The lamp is working, the lamps are on. The manufacturer does not recommend the use of their lamps in systems with dimmers, timers.
The 20-watt LED lamp shines well, like new.
It took me 2 hours to photograph this time for this alteration of an old non-working luminescent lamp for ECO LED lamps LED TB-10W-865-G13-600mm.
Good luck