Today I want to tell you how to do it in home conditions home-made pump for overflowing water ...
To begin, I suggest you watch a video about this homemade:
[media = http: //www.youtube.com/watch? v = iY19PLrMQvw]
Probably many people have ever had the problem of transferring water from one vessel to another ... Of course, you can simply lift and turn one vessel over another, but ... this method is not always good, since the vessel can be large, that is You’ll have a lot of weight at the tank and you just won’t be able to physically raise the tank ...
The second way is to pour, for example, in circles ... But this method is also not always good, because, for example, the shape of the vessel may not allow you to draw water in circles or any other circumstances ... And then an old, verified a way to transfuse a liquid is to take a flexible hose, lower one end of the hose into a container of water, and take the other end of the hose into the mouth and blow air into yourself ... Pressure will build up and then the water will inertia pour from one vessel to another while you do not pull the hose ... Simple physicist a, but ... this method is not very hygienic, besides with a bad set of circumstances, you can even choke on water ... Therefore, this method is quite dangerous ...
And in this article I want to share with you a “recipe” on how to do it myself; I don’t apply much effort to a homemade pump to transfer fluid from one tank to another ... Moreover, this method is safe ...
So, let's begin...
In order to make a pump we need:
- a bottle cap;
- drill and drill for 8 mm;
- scissors or knife;
- "neck" of the bottle with thread;
- flexible hose;
- a small piece of pipe ...
To begin with, we remove the gasket from under the lid and cut off its edges as shown in the photo, leaving a small "tail" ...
Next, make a hole of about 8 mm in the lid itself ...
Now, carefully place the trimmed gasket inside the lid and twist it as shown in the photo ... Our trimmed gasket will serve us like a valve ...
Next, we put our cap with valve on the pipe ...
On the other bottle, cut off the “neck” and do something like a turbo water intake ...
Now from the other end of the pipe we put on a flexible hose ...
That's all!!! Our water overflow pump is ready ...
Now we lower the side of the pipe into the tank with water where the valve is located, and we pump up the pressure with sharp movements up and down ... Water flows through the valve into the pipe and further into the hose, and from there it flows out ...
Good luck ...