When I come to the village, I constantly encounter the problem of covering a mobile operator, the signal is weak or it doesn’t exist at all = (and then I got tired of it and I made an antenna for my mobile phone.
How I did it, I'll tell you now.
And so, to create an antenna we need:
• Antenna from an old receiver
• A piece of thin wire
• screwdriver
• Little washer
• Soldering iron and soldering accessories
I would like to start with the fact that the network does not catch, not a single stick = (
And now I can start ..
We take our antenna and disassemble it at the base.
We take our washer and solder the wires to it.
IMPORTANT! Before soldering the washer, it is necessary to clean and tin.
Now when everything is ready, we are assembling our design.
We remove the phone cover and what we see .. We see the connector for connecting an additional antenna.
Now we strip the wire from the other end by 1-2mm. It is no longer necessary that there is no short circuit of the golden little thing (contact) when we insert the wire into a small hole that is located in the center of the connector.
When we fix the wire, you can turn the phone over and look at the network indicator.
And what do we see ?, 6 out of 6! Not bad, right?
And so, the whole assembly is assembled
And now for the experiment, turn off our wire, wait a couple of seconds and look at the indicator, and we see that the signal has disappeared again.
Here it is, here is the antenna .. Good luck to everyone!