Every family with children sooner or later faces the same problem: How to teach a child to use a toilet after a pot? This period falls on the age of 3-5 years, and sometimes a little earlier. To begin with, as a rule, a special children's circle is purchased, which is attached to the toilet. But the child is not able to reach him? In this case, smart parents usually leave a small stool in the bathroom. We bring to your attention an alternative in the form of a stand, with the help of which the child can easily get to the toilet. Its manufacture will not take you much time.
Necessary materials
• Boards (can be pallets)
• Saw
• Jointing machine
• Wood glue
• Screwdriver
• Self-tapping screws
• Electric Planer
• Wide board (1 piece)
• Jigsaw
• Varnish
Pick the same sized boards.
It is necessary with the help of an electric planer to make the surface of the boards very smooth so that the child does not get hurt. This will make them the same thickness.
For joint seaming, boards should be machined with a jointing machine, especially if pallets are used.
Then you need to grease the side parts of the boards with special glue for wood and join in one large surface. Divide the remaining boards in half and glue. Their length should correspond to the width of the surface. These will be the legs for the stand. Connect the entire structure with a screwdriver and self-tapping screws.
Next, you need to cut a semicircle in the middle of the wide board (at your discretion). This is done solely for beauty.
Measure the length and width of the toilet. The stand should be up to the middle of the toilet. According to these sizes, cut out the rectangle at the back of the stand with a jigsaw. For convenience and beauty, round corners.
All surfaces must be varnished.
Your child will be satisfied!