Many people like to model airplanes. If you also love this business, then you should definitely read this review, since it is devoted to the manufacture of a flying model of an airplane.
We recommend starting with watching the author’s video
We will need:
- cardboard;
- ruler;
- a small wooden block;
- threads;
- glue;
- paper clips.
First you need to cut out all the details of the future aircraft from cardboard. Below is a diagram to simplify the work. If desired, you can change the size, be sure to keep the proportions.
After all the parts are cut out, it is necessary to bend the screw with an eight.
Next, take a small bar and solder it with a knife from both ends.
Further, from all sides we trade the bar so that it becomes thinner.
We grind the resulting base with fine sandpaper, trying to give it a perfectly even shape.
We proceed to the manufacture of the rear blades. To do this, glue the corresponding cardboard parts to each other, additionally fixing them with small square pieces and hot glue.
Next, you need to glue the resulting part to the base with a thin layer of hot glue. The author advises using a glue gun for gluing parts onto the base, since it is much more convenient and comfortable to use than superglue.
Take the rod from the handle and cut off a small piece - about half a centimeter.
Below is a diagram for the manufacture of a motor that will rotate the propeller.
For greater clarity, we present several copyright photographs of the finished model.
