We present to your attention an overview of the video on the manufacture of a lamp, which will rotate one of the elements from the heat that the bulb will create.
Let's start with the author’s video
So we need:
- a bulb;
- cartridge;
- two screws;
- a small board;
- a bottle of kefir;
- power cord;
- a can from Coca-Cola;
- aluminum wire;
- glue gun.
First, on the bank from Cola, you need to cut out arbitrary shapes.
Then cut off the top of the jar.
At the bottom of the can, we cut the blades.
Using a screwdriver from the inside on the bottom, make a small depression.
In a bottle of kefir, it is necessary to cut the bottom and trim the upper part.
We connect the wires to the cartridge and isolate. You can do this with a glue gun.
Now you need to screw the cartridge with screws to the board.
We check the design.
We take an aluminum wire and give it the shape of a spring. Do not wrap the top of the wire. The tip must be sharpened with a file.
We put a rounded wire on a light bulb, after which we install a bottle of kefir. After that, we fix the bottle with a glue gun.
We put a can of Coke on the sharp end of the wire so that the sharp end is in the recess.
Turn on the lamp and the can starts to spin after about 2 minutes.
The lamp casts beautiful shapes, which looks very beautiful.