One of the most important facilities in the economy is the greenhouse. With its help, you can grow a variety of crops that are not suitable for the usual natural climate. Also in unexpected frosts or strong hail, the greenhouse will save your vegetation from adversity.
Unfortunately, a purchased greenhouse costs a lot. If you do not have extra money, you can do it manually by reading our step-by-step instructions. This will help you save a lot.
For the manufacture you will need materials such as:
- pre-treated with a special solution against decay, wood;
- PVC pipes;
- fittings;
- a couple of rolls of film;
- lathe;
- nails and screws;
- metal plates;
- door handles with hinges.
And so, step 1. We begin by giving the conceived shape to our greenhouse, knocking down boards. To firmly fix the structure, we drive reinforcement in the corners.
Step 2. Carefully cut about 30 bars of reinforcement. Between the rods, evenly install the reinforcement, digging it into the ground so that it has stability and can withstand a heavy load.
Put PVC pipes on the sticking rods to connect them together.
Fasten all pipes tightly with metal loops.
Step 3. From the boards, it is necessary to cut several bars of different lengths, carefully look at the figure.
For more reliable structural stability, a small bar should be nailed at the corner of the greenhouse.
From small sections of pipes, one should be made long, it must be attached to the transverse arches.
Step 4. We cover the entire greenhouse with a film. For fastening, it is best to use staples or wooden battens, they are more reliable and will not damage the film.
Over time, the film can sag much, so that this does not happen, the greenhouse should be done in warm weather.
Tighten the front and rear of the greenhouse with foil. Where the door will be installed, do not forget to wrap the film inside.
Step 5. In the manufacture of doors, accurately perform all measurements. First, knock down the bars, then fasten the film to them. Carefully cut off all excess from the film. Fasten the hinges to the door.
For the role of the door for your greenhouse, plywood or plastic is suitable.
Securely fasten the door to the frame. That's all, the greenhouse is ready. It will take you just one weekend to make it.