» Fixtures »Original do-it-yourself stand for reading

Original do-it-yourself stand for reading

Original do-it-yourself stand for reading

Hello to all lovers homemade, in this article I will tell you how the author made a very interesting and useful reading stand do it yourself. To do this homemade product is not so difficult, you will need an initial level of knowledge of working with wood, as well as easily accessible materials. The idea of ​​homemade content is simple and clear, it’s not always convenient to sit with a book in your hands, and this stand will also help in writing home work or any write-off, it’s also convenient to install a tablet in it or electronic a book.

In order to make an original stand we need:
* Electric fretsaw.
* Sandpaper.
* Glue for wood.
* Wooden planks.
* Clamps.
* Pencil and tape measure.

All materials and tools are ready to go, so let's get started.

Step one.
The first step is to draw a sketch of the future stand, as well as designate the dimensions of each part separately, which will not give you the right to make a mistake and save you from alterations and removing jambs at work. According to these sizes, a stand will be built.

Step Two
We directly proceed to sawing the boards of the required sizes, for this we do this using a jigsaw and sizes, it is necessary to saw strictly along the line that we previously draw with a corner, which is guaranteed to give an even angle of 90 degrees. When operating a power tool, be careful to also be vigilant and wear safety glasses and gloves.

By such actions, we cut the necessary parts step by step so that the part sits firmly, it can be pressed with a clamp to the workbench during sawing.

Step Three
All the elements of the stand made in the previous step need to be glued together, but need to be glued correctly, namely apply glue to the glued surfaces with a thin layer and evenly, which will give a greater result in the end.

Also, do not forget about the legs of the stand, which are made of long boards inserted into the recess. In order for the parts to stick together without your intervention, it is necessary to clamp them with clamps.

After the glue dries, which usually lasts 24 hours, you can use the stand for its intended purpose. For completeness, we polish the surface, which will give the homemade product more beauty.

Thank you all, good ideas to you.
7
8
7.7

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose
1 a comment
How to store this "cuttlefish" in the intervals between its use? Conventional "school" coasters have folding stops, so when folded they have a minimum thickness. And so - for the labor lesson in the fifth grade - that’s it.

We advise you to read:

Hand it for the smartphone ...