And so for him we need:
- eight sheets of A4 paper
-strong thread
From the tools we need:
thermo glue
-scissors
And so, first you need to make a thin tube. To do this, take a sheet of paper and tuck the end a little to it, after which we begin to roll up the entire sheet of paper, then glue the end. We should get such a tube, the thinner the better. We make 4 such tubes.
We take another sheet of paper, apply a thin tube as shown in the photo and make a thick tube. In total, we need 3 of these tubes.
Now cut each thick tube into the sexes:
We glue two of them:
One of the halves is divided again by gender:
Then glue it on our last blank exactly in the center:
We cut about 4 cm from the thin tubes from the ends, since they are thin:
Glue one of the thin tubes to our workpiece, as shown in the photo:
On the reverse side, we do the same:
And on the other side we also glue two thin tubes, just as we did before:
We take two more sheets of paper and make two more thin tubes, then cut them 4 cm on each side.
Then we take two more thick tubes and glue them, after which two thin tubes need to be glued on them. We do everything as shown in the photo:
We take a thick thread and begin to wind the end on one side of our bow, after which we fix it all with thermal glue. Then, observing the tension, go to the other end and do the same.
That's it! Our simplest paper bow is ready and it remains only to test it. As arrows, you can use either barbecue skewers or stick rods. You can believe it, you can not, but the bow really shoots and shoots pretty well! And follow safety precautions!
Thank you all for your attention!