Yes, I soldered the watering from the same pipe, the photo is attached.
Greenhouse greenhouse self-watering
Good day to all! I soldered a greenhouse-greenhouse here, I want to share it. The greenhouse is soldered from 20mm polypropylene pipes, length 6m., Height 84cm. The result was such a greenhouse-water supply. I drilled 1.5mm holes in the upper pipe. I connected a hose and she watered herself. Bottom discharge of water for the winter. On top, I later pulled the agril and fastened it to the 20mm clamps. Bent pegs will be kept on the lower perimeter, just in case from windage. Of course, you can do without watering, it’s so ... a stormy fantasy. The greenhouse is mainly from the invasion of blackbirds. Well, it turned out to be very budgetary 1200 rubles. If you remove the fittings for irrigation, another minus 100 rubles. Assembly time (soldering) is approximately 4 hours. Videos and photos are attached.
Yes, I soldered the watering from the same pipe, the photo is attached.
Yes, I soldered the watering from the same pipe, the photo is attached.