Those who have a wood lathe can try to make a segmented bowl. In this article, we will use a wizard to explore how to make it. To do this, you need the following
Tools and materials:
-Lathe;
-A circular saw;
-Tools for grinding;
- Paint tape;
-Template
-Wood of valuable species;
-Shellac;
-Brush;
-Glue;
-Office gum;
- chipboard;
- hairpin;
-Wind screw;
- Clamps;
Step One: Making Segments
For his bowl, the master uses paduk (mahogany) and walnut. Using a template, cuts the workpiece.
Then it polishes and adjusts the workpieces. Collects rings from segments, fastens with office rubber bands.
Step Two: Bonding
After the master made sure that all the parts fit glued them together.
Step Three: Grinding
The rings are stuck together, now it polishes them on a disk grinding machine.
Step Four: the bottom of the bowl
From wood makes the middle part of the bottom of the bowl.
Glues the core into the bottom of the bowl.
Step Five: Clamp
From a chipboard makes simple device fixture. Board with a pin in the center and a pressure board.
Step Six: Bonding the Bowl
Bonding master begins with the upper rings. Glues 2-3 rings at a time. When gluing, special attention is paid to the alignment of the rings.
Glues the bottom of the bowl. Fixes with clamps.
Seventh step: turning
Turns the bowl on a lathe.
Unfortunately, when processing the bowl on a lathe, the bowl broke. The master had to glue it again.
Step Eight: Sanding the Bowl
Grinds the bowl from the outside and from the inside.
Step Nine: Varnishing
Applies shellac to the bowl.
The bowl is ready.