» Fixtures »Place for grinder

Place for grinder

Hello.
I decided to make a place for angle grinders, cutting discs and other things for her, so as not to wallow over the garage, but was in a certain place. And also for convenient transportation to the country, etc.
And I got such a box for the "Bulgarian".

To make this miracle I needed:
plywood 8-10mm
hinges
locks
a pen
roller and paint

From the tools:
ruler square
saw
screwdriver
jigsaw
clamps
To begin, draw the dimensions of the blanks on plywood and cut


Immediately I paint the sawn parts with black paint


After drying, I fasten with an angular clamp, I mark out and drill holes for fixing the walls


fasten


also screw the bottom


hinges



locks



pen




further inside the drawer I make a partition


and place the tool



I cut a stencil of angle grinder on sheet A4


and paint silver spray paint


Everything is ready, thank you all and good luck.
8.3
7.3
7.8

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose

We advise you to read:

Hand it for the smartphone ...