In the article Oxygen cylinder rocket furnace The master showed us how to make a stove. In this article, he will tell us how to make a hob for this stove. The panel consists of a heating radiator having two sections. Mounted on top of the furnace pipe. The principle of operation is clear from the photo. The panel is mounted on the stove, and the front side heats up. The master closes the sides, and the gases go through two side chimneys.
Tools and materials:
-Radiator;
-Detail of a gas bottle;
-Scraper;
-Grinding machines;
-USHM;
- Corner;
- Bandsaw machine;
-Welding machine;
-Clamp;
-Izolenta (blue);
Step One: Clean Up
First you need to clean the battery from old paint. The master wanted to burn the paint, but it turned out to be heat-resistant.
Then he took up a hand tool.
The scraper helped a little and the grinders came to the rescue.
Step Two: Center Hole
Having cleaned the front side, the master proceeded to cutting the central hole. Draws two circles. The inner carves completely, the outer only one wall.
Checks panel installation.
Step Three: Corner
Now you need to close the sides of the radiator. Cuts a corner to fit.
Welds a corner around the perimeter of the radiator, closing the hole between the two sections.
Step Four: Chimneys
Cut through two holes for chimneys.
To install one chimney, it uses a part of the gas cylinder, the other fastens with the help of corners.
The main thing is not to forget about the blue electrical tape.
Cooking, or rather frying panel is ready.