» Fixtures »Dust collector for self-drilling holes

DIY dust collector

Hello dear readers and the inhabitants of our site!
it device It will be very useful for everyone who drills holes in clean rooms, and does not like to clean up the consequences after that. In this article, Roman, the author of the YouTube channel "all ideas" will show you how to make a simple dust bag in 2-3 minutes!

Materials
- A piece of PVC pipe with a diameter of 12 to 20 mm, a length of 20-30 cm
- Fingertip, finger trim from a rubber glove
- The tube diameter drill.

Instruments, used by the author.
- Screwdriver, drill
- scissors
- Knife
- Hacksaw.

Manufacturing process.
The novel cuts a straight section from a piece of a broken pipe at an angle of about 30 - 35 degrees.

The unevenness of the cut removes with a knife. Ideally, you can sand, make a rubber seal. But this is for your imagination.




Then a hole of a slightly larger diameter is drilled in this place than the one for which the device will be used.



Inserts a tube into the drilled hole and cuts it with scissors.




The main part of the device turned out.


The author makes a bag for a dust collector from an unnecessary rubber glove. You can use fingertips, product number 2, just a bag. Everything is at your discretion.


Puts the dust bag on the tube and the device is ready to go!



When drilling without it, a lot of dust flies, sits on expensive wallpaper and the like.


The novel tests its adaptation in action. Presses the beveled edge against the wall, and drills through a tube.




Well, here it is, the result. It is enough to remove the dust bag and throw away the dust. Although you can not remove it, just turn the tube over and shake it out.



It goes without saying that the diameters and variants of this device can be completely different. You can do this for a hammer drill on the 32nd drill from a plumbing pipe, and do not kill the house vacuum cleaner with concrete dust. The only problem is that this fixture will not work on ceilings.

Thanks to Roman for an excellent tip for all the residents of our sites and not only!

All clean work and consciousness =)
5.9
6.3
5.7

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose
25 comments
Author
And if the wallpaper is silk, super-mega-expensive, then what kind of tape? And besides a puncher, a screwdriver, a grinder and a step-ladder, you can also drag an industrial vacuum cleaner with you - in general, then the transfer laboratory will work =)
You can’t do the job seriously and cleanly at the same time.
You, work, do not be afraid of me, I will not touch you, well, and you do not touch me! smile
So we, it seems, are not on the site of professionals. If I need to drill a dozen holes a year in the wall, then buying special equipment for this is extremely irrational.
Maybe you don’t know, but professional “wall drillers” (it’s me trying to make fun of our homemade artisans) have industrial vacuum cleaners that are turned on with the tool, be it a angle grinder or a drill. They work for a newspaper or a pipe Sorry, not professionals, but amateurs or altruists.
We are now talking about a vacuum cleaner FOR a power tool ... It's about that which the tool itself is vacuuming!))))
(By the way, I really had to. And the puncher and the suitcase ... with a vacuum cleaner are easier and it pulls out the grills ...
And when drilling, so personally, as I already wrote, I consider all this mischief, and just lay a newspaper ....
And according to the wallpaper, I never smeared anything ... If the dust adhered slightly, then collecting it with the same vacuum cleaner is easy ...
And in the plaster, drill holes ... So there is more dust from the panel and the hammer drill ... And that isn’t scary ...
Pampering all this ... You can’t do the job seriously and cleanly at the same time ....
So, I already offered an ejector pump made of cardboard with tape, mount directly on the body of your screwdriver. and leave this thing of yours (well, the one that is a pity to throw out) to descendants.
Quote: Valery
And somehow the newspaper does not bother me to spread it, and then collect and vacuum it!

So, after all, the dust not only flies down, but also the female dog tries to spread it on the wallpaper. A paper bag glued with paint brushes, tape or tape under the hole helps a lot, but not completely, besides it needs to be glued to each hole.
For this, the "classic" is better ...
Nothing comes to mind ....
Vacuum cleaner for power tools! smile
Me too! Red and white. The "breeze" seems to be called ... Already a couple of times I thought, to make something out of it - to throw it away is a pity! Working ...))))
Nothing comes to mind ....
And somehow the newspaper does not bother me to spread it, and then collect and vacuum it!
Well, again, you are pushing me into stupid thoughts! Lying around idle old Soviet clothes brush-vacuum cleaner, remember this? Put it in a plastic bottle, cambric to the drilling site! smile
Sorry for the directness, and who holds this "ingenious fit" while you "drill the wall"? Sounds somehow far-fetched, don't you think so?
So here, in order for her to drill a drywall with a screwdriver. You can hold it yourself with your left hand ...
And somehow the newspaper does not bother me to spread it, and then collect and vacuum it!
I saw about a glass and also neighing! I knew that there are "sofa masters", but, damn it, SO SO !!!! ??? )))))
... If I drill the ceiling, I put a regular rubber "plate" on the drill to collect dust ... But this is so that it does not clog the punch cartridge!
Are you kidding?
Seriously! I bought, assembled, installed a new furniture wall, an outlet in the wall right in the area of ​​the TV niche, God himself ordered to make a window!
Quote: Korolev
I cut it out!

fool Are you kidding?
Quote: LeoBrynn
Especially when you come to install the intercom
And you need to drill the wall.

Sorry for the directness, and who holds this "ingenious fit" while you "drill the wall"? Sounds somehow far-fetched, don't you think so?
I saw a window under the switch
I cut it out!
I saw a window under the switch, so I didn’t laugh at Zadornov’s joke.
the new wardrobe closes the old
Is the window in the back of the cabinet weak? smile
Common situation. And even when the European-style repair was done, the feldipersy wallpapers were glued, and you are asked to transfer the outlet by half a meter because the new closet closes the old one, but we really need it and we do not want extension cords.
Author
Especially when you come to install an intercom, and in the apartment there are elite silk wallpapers and “we don’t do a vacuum cleaner;
And you need to drill the wall.
The cup does not stand any comparison. Here the main point is in a slant obliquely.
Here all the charm - in simplicity. No hassle with a vacuum cleaner, especially convenient "away".
Author
You can glue a soft rubber on the edge of the plane of contact with the wall

I immediately wrote about it, but did not develop the idea
Ideally, you can sand, make a rubber seal.
And you can also mount an ejector pump on the drill body, and attach the suction nozzle to the floating bracket .... one glove and a piece of cardboard should be enough. Sorry for trolling, but there was already an offer to drill through a plastic cup.
The pipe is thicker and the syringe instead of a condom. And then no gum is needed ... Only it will interfere
You can glue a soft rubber on the edge of the plane of contact with the wall or apply a silicone sealant roller. And the requirements for precision clamping will decrease, and potential damage to the surface will decrease. And the idea itself is great.

We advise you to read:

Hand it for the smartphone ...