I love to make birthday presents!
So this time, I decided to approach the approaching birthday of my friend Alla, to give her a present.
She herself does not know how to fly and model she doesn’t need at all.
But she will be pleased that the model named after her will soar in the sky.
So began the creation of the Scarlet aircraft model,
He took the Penoplex insulation 20 mm thick. cut according to these drawings and glued.
Tightened with tape
already set the servos, pasted the hogs, connected the rods, set the motor with the screw, and it would be possible to test.
Yes. as always, a bad head does not give rest to hands ... Something to me the model seemed bulky, awkward.
I decided to make another model, which will be smaller, more careful and have less weight.
And he started all over again.
According to the same drawings, only a little smaller.
This time I took it - a simple substrate under the laminate, blue, 5 mm thick.
I cut a wing from two sheets of a substrate and glued it together.
The fuselage is mounted on it, for which special cutouts are made.
The part of the fuselage on which the redan is located is mounted below.
As soon as ready, I fit the model with colored tape.
Of the two layers of the substrate glued keels.
He glued the cabin, as usual, cut it out of a plastic bottle, cut the figure of the raft out of the backing and painted glass on the helmet with a black felt-tip pen.
I cut a Penoplex from a piece of insulation, 2 cm thick. I prepared a workpiece and glued a piece of hardboard to it. The motor will be attached here.
Set everything in its place.
He made an inscription on the keels.
Elevons hung on tape.
Set hogs, servos, connected traction.
Put the motor in its place.
A bit about the model.
Length - 1200 mm.
Span - 940 mm.
Motor - 3010 1400 Kv. 420W.
Screw -13 x 8.
The regulator is 40A.
Servos - NHT900.
The battery is 2200 3S.
The model is ready to fly.
On Alla’s birthday, we’ll make a test flight!
Give people joy, Hurry to do good, you may not have time!