In this article, the author of the YouTube channel "jisaku-kobo / 自 作 YouTube" will tell you how to make very long clamps in just a few minutes.
Moreover, for this homemade sophisticated tools and expensive materials are almost unnecessary.
Materials
- Nuts, washers M10
- Hairpin M10
- Plastic lamb nut M10
- Board, or thick plywood.
Instruments, used by the author.
- Miter saw
- Screwdriver
- Wood drill 10 mm
- clamp
- Spanners
- Roulette, pencil.
Manufacturing process.
So, the author marks the board along a length of 200 mm, he needs two such blanks. You can change the size to fit your needs.
With the help of a guide and a miter saw cuts off the excess.
Then cuts the workpiece in half.
He presses the workpiece to the table through the pads with a clamp, and drills a pair of 10 mm holes. After this action, it is desirable to process the ends and faces with sandpaper, and soak in oil or wax.
Screws a nut onto a stud, puts on a washer.
Then he inserts the studs into the clip, puts on the washers and tightens the nuts with the keys. One side of the clamp is ready.
It removes the plug from the lamb, drills a 10 mm hole in its center, the second edge of the stud will exit through it.
It collects the lamb by inserting the nut and latching the lid.
Inserts studs into the second, movable clamp, lays a pair of nuts on each, winds the lamb.
That's all, the clamp is ready.
Now even very long elements can be pulled off with such a tool.
The dimensions of the clamps can be changed, and even make them very small. But this is at your discretion.
Thanks to the author for the simple but useful device for the workshop!
All good mood, good luck, and interesting ideas!