The master has long wanted to build a house in the forest. Finally, having acquired the site, he set about construction.
Tools and materials:
-Lumber:
-Cement;
-Sand;
-Crushed stone;
-Proflist;
-Construction machinery;
-Fasteners;
-Ruberoid;
-Various construction tools;
-Generator;
-Wire;
- OSB;
-Plywood;
- Thermal insulation material;
Step One: Plans
Any construction begins with a plan. The size of the house, according to the plans of the master, is 3.65 * 3.65 meters. The porch size is 1.82 * 3.65 meters.
Step two: choosing a place
The plan is ready, the material is purchased, the equipment is rented and the master proceeds to the choice of the place of construction of the house. And here the first difficulties awaited him. According to the plan, the house stands on stilts. The installation depth of piles is 36 "(91 cm). But it turned out that under a small layer of soil, at a depth of 6" (15 cm), the rock. The master had to look for another place to build a house. As soon as the control drilling was successful, the master cleaned the area, marked out and drilled the wells.
Step Three: Install Piles and Foundations
The master installs piles and pours concrete. Then aligns the piles and ties with transverse boards.
Makes the base and planks the floorboard.
Step Four: Walls
Installs floor slabs. Sheathes the walls of the OSB.
Step Five: The Roof
Installs the supporting beam and rafters.
Secures OSB sheets on the roof.
Spreads ruberoid.
Step Six: Porch
Further the master makes a porch. The house and porch go under one roof. Temporarily the roof had to be covered with a tarp.
Seventh step: power supply
The house is powered by a 120 V alternator. A helium battery is installed in the house, which supplies four 12 V LED lamps. To turn on / off the fixtures, the master sets the passage switches.
The room is equipped with air conditioning, which is also powered by a generator.
Step Eight: Decking
Covers the roof with corrugated board.
Step Nine: Exterior Finishing
Sews the outer walls of the fiberboard house.
Step Ten: Thermal Insulation
Before fixing heat-insulating materials, the master puttyed all the cracks. Installed thermal insulation on the roof and walls.
Step Eleven: Interior Finishing
Sheets panels with walls. The laminate is laid on the floor.
The house is ready.