Such drills will help expand the functionality of dremel, drilling machines, electronic or hand drills. They are perfect for drilling holes of especially small diameters in printed circuit boards, metal, plastic, rubber or wood. Drills of increased hardness, wear-resistant, and also resistant to bending. Each drill is equipped with a colored landing stop for ease of installation (each drill diameter corresponds to a specific stop color). Drill shanks are marked with their length and diameter.
The following options are available to order (always 10 pieces):
• from 0.3 mm to 1.2 mm (1 mm pitch);
• from 0.1 mm to 1 mm (1 mm pitch);
• 0.1 mm;
• 0.2 mm;
• 0.3 mm;
• 0.4 mm;
• 0.5 mm;
• 0.6 mm;
• 0.7 mm;
• 0.8 mm;
• 0.9 mm;
• 1 mm;
• 1.1 mm;
• 1.2 mm.
Drills are packed in a convenient transparent box made of soft plastic.
The characteristics of the drills are as follows:
• material of the cutting part: tungsten carbide;
• shank diameter: 3.175 mm (suitable for 3.2 mm collet clamps);
• total length: 38mm;
• length of the cutting part: from 5.5 mm to 10.5 mm (depends on the diameter of the drill).
Drills of good quality, perform their task with dignity, are presented in a wide range of diameters and will occupy a worthy place in the arsenal of each master.
Cost: ~ 121