I welcome all fans to craft, today we will consider a simple and multifunctional oven. The material used was sheet steel and square shaped pipes. The furnace is equipped with two fire chambers and two cooking planes. Thanks to this design, you can cook with someone together if you are going out in the country. And you can cook yourself, if you need to cook many dishes at the same time. The owner also has a small oven in which the author successfully bakes potatoes. And if you need to heat a kettle or other large volume of water, you can put the container directly on the chimney, there is a support. In assembly homemade not complicated if the project interests you, I propose to study it in more detail!
Materials and tools used by the author:
Material List:
- square shaped pipes;
- Sheet steel;
- steel bars or fittings;
- bolts and nuts;
- paint for metal.
Tool List:
- grinder;
- welding machine;
- roulette;
- ruler;
- drill.
Furnace manufacturing process:
Step one. Housing and furnaces
First of all, we need to cut a square pipe at an angle of 45 degrees, so that in the end we can then weld the pipes at an angle of 90 degrees. As a result, we get two cooking planes.
We also cut fireboxes, their author cuts out also from a square pipe, do not forget to cut holes in the pipes inside the furnace body. The loading of firewood into the furnaces takes place from above, the grates and blowers are at the bottom.
Step Two Burner
We make a tip for the chimney, or immediately make a burner directly on the chimney. The chimney is also made of square steel pipe. We cut out the triangular parts of the metal at the end of the chimney, and then bend the ends of the pipe out. In conclusion, the author will weld a cross-piece from a round to the formed ends. The author cut the exit under the chimney with a plasma cutter.
Step Three Grids and doors
We make grid-irons for combustion chambers, for such purposes the author used a round timber, fittings are also suitable.
We also make doors for all openings of the combustion chambers, this will allow you to adjust the traction. If one of the furnaces is open at the time of the other, there will be problems with traction. The author made the doors out of sheet steel, and bolts with nuts were used as hinges. In order for the thread to serve for a long time and not rust, we lubricate it with graphite grease. At the end, we weld the stops for the doors of sheet steel.
Step Four Legs and handles
We make legs for the furnace, you will need fittings, pipes or other rods. To prevent the legs from becoming dirty in the ground, the author welded steel nickels to them. We weld the rods to the doors (dampers), which will serve as handles.
Step Five Oven
We make an oven, for such purposes the author used thick sheet steel. Of course, for a more productive operation of the oven, it would be nice to make it thermal insulation, at least from below. We weld the necessary box and do not forget to make a lid for the oven with a handle that will not heat up.
Step Six Painting and testing
We paint the furnace with heat-resistant paint, now the steel is perfectly protected, and the furnace looks wonderful. Getting to the test, the author ignites the furnace with a gas burner. However, you can put paper on the bottom of the furnace, on top of firewood, and then set fire to the whole thing from below, through the blower. The oven works perfectly, on small cooking surfaces you can fry eggs, heat the kettle and much more. In the oven, the author managed to bake potatoes, and on the burner you can heat a kettle of water. Of course, the oven of such an oven will work most effectively if both furnaces are heated.
The project is completed on this, I hope you liked the homemade work, and you found useful thoughts for yourself. Good luck and creative inspiration, if you decide to repeat this. Do not forget to share your ideas and homemade things with us!
